Jeep Grand Cherokee Remote Start Turns Off. I tried it again and the doors locked and lights flashed and it started the process of starting but the engine did not turn over. 1 climb into your jeep grand cherokee with your keyless remote(s) in hand and your manual ignition key.
Remote start turn on the jeep then it shuts off after 10 seconds. Press and hold the foot brake down. Your parking lights will flash once.
It's More Than Likely The Sensor But Is It Only The Cel That Comes On Or.
It would start, but only run for about 10 seconds and then shut off. Your parking lights will flash once. I fixed my intake runner issue and the remote start functions normally.
3 Turn The Key To The Run Position And Aim The Keyless Remote At The Steering Wheel.
Jeep starts fine when i insert the key. Do not close the driver's door. (if they flash more than once, you may have to visit the dealer/installer) turn the vehicle off.
Asked By Drew9977 Jan 21, 2015 At 06:07 Pm About The 2008 Jeep Grand Cherokee.
2 hit the lock switch on your driver's side door and insert the key into the ignition. Remote start turn on the jeep then it shuts off after 10 seconds. 2014 black jeep patriot, latitude, fdii, sun and sound package, remote start 2015 white jeep grand cherokee, limited, luxury group ii 2010 ford f150 lariat, 4×4, 5.4l v8.
I Tried It Again And The Doors Locked And Lights Flashed And It Started The Process Of Starting But The Engine Did Not Turn Over.
My remote start is not working properly. It worked fine yesterday morning. While keeping your foot on the brake, press the remote start button on your remote control for 3 seconds like you are remote starting the vehicle.
This Morning My Jeep Started Then Shut Off Within A Few Seconds.
The reason the remote start shuts the vehicle off is the computer is causing it to go into fault protection mode and turning the vehicle off to protect the engine from damage. Jeep starts fine when i insert the key. Remote start turn on the jeep then it shuts off after 10 seconds.