Idatalink Remote Start Not Working. Complete next step within 7 seconds. Parking light flashes | troubleshooting your remote starter;
Plugged the t harness up. .i forgot to cut the loop (manual transmission loop wire on module)before programming. I disconnected the battery once, now my 2 way automate remote start works but i only from max 20ft range, before i could start from the middle of the mall.
Login Was Primarily Implemented To Enable Our Support Staff To Better Identify Our Customers And Leverage Idatalink’s Black Box Technology For Troubleshooting Purposes.
When your idatastart remote starter is detected it will offer you to go to the new weblink page. Vehicle not in ‘park’ as a safety precaution, the remote start system will only work if the car is in ‘park’. Complete next step within 7 seconds.
My Vehicle Remote Starts But Then Immediately Shuts Off.
Programming went exactly as shown in install guide no problems there. • do not remote start a vehicle while it is being serviced. • do not remote start a vehicle with the key in the ignition.
(See The Module Diagnostics Page) Release The Brake Pedal.
Jan had the samething today 9 red blinks.fristrating but my fauly for not following instructions.my car is an automatic transmission. Flashed it with the remote start firmware. This is all it called for.
Choose “Connected Rf Kit & Telematics”
.i forgot to cut the loop (manual transmission loop wire on module)before programming. Install went well however it will not start the vehicle. (see image #2) this will bring you to the older weblink page.
The Following Applies Only When The Parking Lights Are Connected And Supported By The System.
Hooked up my own hood pin (green/ black wire on module), tapped into drivers door trigger(green wire on module), and hooked up a valet switch (blue/black on module). 02 key in ignition at on position. • foot brake is depressed.